Shop time
#61
Painted the vaccum tank and will use in house stencil on it. Lots of fitting but finally got inner rear bulkhead welded in now a lot of finishing to do.
Hmmm, smells good almost done!!
A few rust depressions I couldn't get out, but good integrity and ready to rebuild the rack
Its in to stay now
Its in to stay now
Trial fitting the bulkhead
Fitting the brace
Hmmm, smells good almost done!!
A few rust depressions I couldn't get out, but good integrity and ready to rebuild the rack
Its in to stay now
Its in to stay now
Trial fitting the bulkhead
Fitting the brace
#62
Another monocoque metalworks piece (upper quarter cP), needed to add a little touch to custom fit but as always a good panel
end cap added to piece
Mice profile/fit
Getting there
NOS wing STILL needed some time on the english wheel to fit
Edge curved into much, so wheeled it to bring out and will use planishing hammer and slap hammer to smooth more
#63
#66
#67
#68
#69
#70
Thanks, definitely takes longer as a one man shop, and a lot of the panels need massaged to get them to work so can only do 1 side at a time to preserve symmetry and compare. The FHC I am doing I had to build the jig before anything and that took a while. Finally got the doors in and can start the final fitment before welding (always nerve wracking to afix permanently!! Hope to get out in shop more this fall
Thread
Thread Starter
Forum
Replies
Last Post
philwarner
XJ6 & XJ12 Series I, II & III
16
09-05-2015 10:05 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)