I have a brand new, never used or even unwrapped Safety Devices roll bar/roll cage for sale. Built in England and purchased through Stable Energies. Paid about $1200 new but would take $800 for it. Can be used as a bolt in roll bar or as a full cage (front pieces bolt into place). Expect shipping to add about $125-150 to your cost unless you have a less expensive alternative. Located near Dayton, Ohio. Contact at: larry(dot)weinstein(at)wright(dot)edu

 

pics?

 

You can see the installed by on the safety devices website.
Jaguar XJ S 6 Point Bolt-in Roll Cage | Safety Devices

Mine is still wrapped in shipping materials if you want to see a picture of the parts. Email me and I can send you those.
Larry.weinstein@wright.edu

 

after looking gain, my Racing seats are far too tall to clear that roof support beam.

too bad, ive been really wanting a cage.

 

Are you sure? That would be unusual since the roll bar and front optional supports are designed for a race car. The roll bar does up to the ceiling behind the front seats. The side bars are on the sides. I can't imagine what could interfere with the top of your seats.

 

The roll bar requires you remove the rear seats to install since it goes up at a light angle from that area. Where it runs side to side along the roof should be some distance from the top of the front seat and from your head. The side bars attach to plates mounted on the back of the door sills.

 

my seats are too tall. they touch the headliner as it is.