Finding error codes with OBD2: O2 Sensor
#1
Finding error codes with OBD2: O2 Sensor
I finally purchased an ELM327 and downloaded the appropriate software to my Android. I was pleasantly surprised at how nice the app works. I was not so happy finding two error codes.
I know I must change one of my O2 sensors, and I know it is one of the two before the catalytic converter. My problem is, where are they located?
While looking around in the engine compartment, I can see two sensors toward the bottom of the firewall. They seem to be attached to something under the car. Could these be the sensors?
What I plan on doing is first checking for a loose connection then reversing them. This way I will know which one is defective.
My JTIS CD is currently damaged and I am not even sure it will run on my PC (I recently upgraded WIN7) even in compatibility mode.
Any help will greatly be appreciated.
I know I must change one of my O2 sensors, and I know it is one of the two before the catalytic converter. My problem is, where are they located?
While looking around in the engine compartment, I can see two sensors toward the bottom of the firewall. They seem to be attached to something under the car. Could these be the sensors?
What I plan on doing is first checking for a loose connection then reversing them. This way I will know which one is defective.
My JTIS CD is currently damaged and I am not even sure it will run on my PC (I recently upgraded WIN7) even in compatibility mode.
Any help will greatly be appreciated.
#2
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)