Urgent: Need Help With Thermostat Housing
#1
Urgent: Need Help With Thermostat Housing
Working on replacing my bad thermostat housing. After taking the housing off that was cracked at the top, I found that the plastic on the inlet tube is bad. I was able to get the front two screws out on the base of the inlet tube but the back two are giving me a hard time. Any advice on getting the back two out?
Just in case, I have a 2003 4.2 NA.
Thanks for any advice.
I will also try to get a picture tomorrow. The car is in the garage and I am toast for the night.
Just in case, I have a 2003 4.2 NA.
Thanks for any advice.
I will also try to get a picture tomorrow. The car is in the garage and I am toast for the night.
#4
I finally go this fixed. What a pain... Long story.... Luckily I had some help.
If any one is interested, I was sold the wrong part the first time (go figure) and I am looking to sell it. Since I tried to install it, (I just tuck out the box) I was given my money back and was told to keep it. I was totally shocked. Bottom line, I have a brand new thermostat housing and gasket, NCE 2247AD Kit, brand new for sale. It fits the 4.0 2000-2002. I will post it in the correct place with pricing and info.
If any one is interested, I was sold the wrong part the first time (go figure) and I am looking to sell it. Since I tried to install it, (I just tuck out the box) I was given my money back and was told to keep it. I was totally shocked. Bottom line, I have a brand new thermostat housing and gasket, NCE 2247AD Kit, brand new for sale. It fits the 4.0 2000-2002. I will post it in the correct place with pricing and info.
Thread
Thread Starter
Forum
Replies
Last Post
mikiep
XK8 / XKR ( X100 )
14
12-20-2019 07:37 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)