What did you do to your X150 today?
#182
#184
The following 6 users liked this post by nw83:
DorsetJag (11-29-2021),
Margaret P. Clarke (04-11-2019),
pwpacp (06-01-2018),
ralphwg (06-01-2018),
Sean W (06-01-2018),
and 1 others liked this post.
#185
The following 3 users liked this post by Cee Jay:
#186
Join Date: Jan 2012
Location: Newport Beach, California
Posts: 5,668
Received 2,677 Likes
on
1,837 Posts
The following users liked this post:
jahummer (06-01-2018)
#188
#189
The following users liked this post:
mrsclark (08-27-2018)
#190
Ha ha, I made it last winter then had it covered with interior match leather. I had purchased the Mina Speed Humps but was not quite as happy with it as I thought I would be. I also like the one-of-a-kind look too.
It was fun and rewarding to design & fabricate it but not something I'd be looking to do again. If you are handy/diy'r it is a pretty straight forward process, alot like boat builders use.
#191
The following 4 users liked this post by ralphwg:
lalavfr (02-12-2024),
Queen and Country (06-02-2018),
Simon Tan (06-01-2018),
Vistacom1 (11-18-2021)
#193
The following 2 users liked this post by Simon Tan:
Margaret P. Clarke (04-11-2019),
pwpacp (06-02-2018)
#195
Join Date: Jan 2015
Location: Naperville, Illinois USA
Posts: 4,741
Received 2,060 Likes
on
1,379 Posts
Replaced the gasket and seals on the LH valve cover, although the gasket was not the direct source of my oil leak. While disassembling, I found the lower valve cover bolt, closest to the firewall was not tight, in fact it probably would have fallen out if the seal wasn’t holding it in place. (Will post more details in my ‘Aw Crap... Oil Leak’ thread on Monday when I’m near a PC.)
The following users liked this post:
Sean W (06-02-2018)
The following users liked this post:
Queen and Country (06-02-2018)
#197
#198
#199
#200
The following users liked this post:
Sean W (06-02-2018)