New bigger growler badge swap on my 2010 grille!
#1
New bigger growler badge swap on my 2010 grille!
I ordered a new style 2013 growler badge for my XK8 grille. It's bugger than the previous badge and I like the black background with the fluting.
It was too big for my XK8 badge plinth so I tried it on my XF. Even though it was too big to fit recessed into the frame molded into the plastic mesh, it did fit flush. I popped out the original badge with a butter knife and a piece of card paper to keep from damaging the surround. Took some patience but out it came.
Then I used some two part epoxy clay and put a large mound on the back of the badge and pressed it in the frame.
Looks great IMO. And my previous badge was getting a little dull anyway!
Any chance a moderator can flip pic! Lol
It was too big for my XK8 badge plinth so I tried it on my XF. Even though it was too big to fit recessed into the frame molded into the plastic mesh, it did fit flush. I popped out the original badge with a butter knife and a piece of card paper to keep from damaging the surround. Took some patience but out it came.
Then I used some two part epoxy clay and put a large mound on the back of the badge and pressed it in the frame.
Looks great IMO. And my previous badge was getting a little dull anyway!
Any chance a moderator can flip pic! Lol
#2
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)