more economic and better alternative for undertray replacement
#1
more economic and better alternative for undertray replacement
ok, I have 3 lost undertrays since my ownership. every single time I tired to find a nice condition used part replacement , either price was near as much as a brand new and in bad condition.
I really had no desire to pay like 100 dollars for a piece of plastic under my car the I will not appreciate its beauty but I still would like to have it for protection
so I went to get a piece of aluminum metal sheet at home-depot( hardware store in case of N America) ,I could not find a single piece of metal sheet like a car body wide and I cut my sheet in 2 and overlap in the middle
lifted up my car and traced the contour of bumper underneath. cut it .
drilled a few holes and secured with screw and plastic ties.
23 dollars of metal sheet and 10 minutes of my time.
I really had no desire to pay like 100 dollars for a piece of plastic under my car the I will not appreciate its beauty but I still would like to have it for protection
so I went to get a piece of aluminum metal sheet at home-depot( hardware store in case of N America) ,I could not find a single piece of metal sheet like a car body wide and I cut my sheet in 2 and overlap in the middle
lifted up my car and traced the contour of bumper underneath. cut it .
drilled a few holes and secured with screw and plastic ties.
23 dollars of metal sheet and 10 minutes of my time.
The following users liked this post:
RJ237 (03-30-2014)
Thread
Thread Starter
Forum
Replies
Last Post
RoyLittle0
XJ XJ8 / XJR ( X308 )
5
05-25-2023 02:38 AM
KarimPA
New Member Area - Intro a MUST
8
09-03-2015 07:32 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)