Headlamp PowerWash - how to replace?
#1
![Default](/forum/images/icons/icon1.gif)
Hi,
On my 1997 Daimler Double Six (LWB) I need to replace the RH headlamp washer. Jet, tube and chrome housing are a single unit which is simply clipped into the bumper. I was looking for information about how to connect the jet's tube to the car's tube. The X300 repair manual of the does not mention this job; I looked in the (much better) workshop manual for the X308. It does describe the process, but it seems that there are significant differences between the two generations.
Has abybody experience what needs to be taken off to reach the place where the tubes are connected?
Thanks & best regards
Martin
On my 1997 Daimler Double Six (LWB) I need to replace the RH headlamp washer. Jet, tube and chrome housing are a single unit which is simply clipped into the bumper. I was looking for information about how to connect the jet's tube to the car's tube. The X300 repair manual of the does not mention this job; I looked in the (much better) workshop manual for the X308. It does describe the process, but it seems that there are significant differences between the two generations.
Has abybody experience what needs to be taken off to reach the place where the tubes are connected?
Thanks & best regards
Martin
Thread
Thread Starter
Forum
Replies
Last Post
RoyLittle0
XJ XJ8 / XJR ( X308 )
5
05-25-2023 02:38 AM
KarimPA
S-Type / S type R Supercharged V8 ( X200 )
11
09-12-2015 08:15 AM
KarimPA
New Member Area - Intro a MUST
8
09-03-2015 07:32 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)