Morning everybody.

My wife's '02 XJR has the ABS light with the ASC/TRAC not available call out on the LED panel.

I have cleaned all the wheel sensors and last year pulled the ABS module and soldered the faulty pins.

Is it possible or common for the module to need repairing again? Only reason I'm asking is because I have better than average soldering skills. I have been to school for micro miniature repair and repaired this so it should have lasted.

 

A few people have stated that they found broken ABS sensor wires causing the problems. Apparently a continuity test is needed, while flexing the wires near the sensors. Fronts seem to be the main culprits.