When replacing my 'V' mounts I lowered the front of the subframe to get the job done. This necessitated removing the lower nut on the u/j that attaches to the splined shaft of the steering rack. When putting things back I made sure the rack was centralised. I refitted the subframe and all went well, until I opened the car door and noticed the steering wheel was just off centre. I would like to avoid dropping the subframe again, is there another way to centralise the steering wheel??? Bill W.

 

The wheel is not hard to remove. See post #2 by Graham in the link below:

https://www.jaguarforums.com/forum/x...g-wheel-73051/